Tank Leaching Gold

        Tank leaching is a mineral ore processing system is leaching by cyanidation in a stirred tank. Usually the processing tank leaching systems are often used in processing gold ore minerals. Mineral extraction of gold cyanidation using a tank in mining has increased rapidly since the mid-1980s. Extraction of gold by using a tank leaching systems typically use a lot of multiple tanks in series within a building. Different from heap leaching are located at the open air. Gold leaching process carried out by stirring the gold ore is mixed with limestone and added with a solution of cyanide in a tank and aerated with air bubbles. The duration of stirring often for 24 hours in order to produce the optimum leaching. And efficiency tank leaching of about 92% to 98% gold content of rocks
     Gold is one of the noble metals and as such it is not soluble in water. A complexant, such as cyanide, which stabilizes the gold species in solution, and an oxidant such as oxygen are required to dissolve gold. As well as from cyanide leaching this is needed in the tank leaching systems on gold cyanidation. The amount of cyanide in solution is required at the time of leaching tank for dissolution can be as low as 350 mg / l or 0.035% (as 100% NaCN). Alternative complexing agents for gold, such as chloride, bromide, thiourea, and thiosulfate form less stable complexes and thus require more aggressive conditions and oxidants to dissolve the gold. Certain types of ore minerals also require a certain dissolution process as well. For example, oxide ore with sulfides have different ways of handling the process. Oxide ore more soluble in cyanide compared with sulfide ore. Therefore, if the sulfide ore to be processed by cyanide leaching should first be converted into oxide by roasting rocks. This explains the dominance of cyanide as the primary reagent for the leaching of gold from ores since its introduction in the later part of the 19th century.
     On cyanide leaching of gold in the tank system, activated carbon is very important to use when in the process of recovery of dissolved gold, either by introducing direct to the Carbon In Leach (CIL) in tank or to the Carbon In Pulp (CIP) separately outside the tank after washing. Carbon In Pulp (CIP) leaching  occurs in two stages in the process in a different tank, while the Carbon In Leach (CIL) slurry of minerals and activated carbon having a tank leaching simultaneously on the same premises. Carbon is then separated from the slurry by screening and have further treatment to recover adsorbed gold. Gold complexes of carbon absorbed directly as soon as the gold dissolves in cyanide solution. CIL is used if the rock contains a lot of natural carbon, because carbon will naturally absorb the gold complex. Add activated carbon in the CIL is more active than the natural carbon.CIL investment cost is less expensive when compared with the CIP so that this method is also used on many people's scale mines are. This method is higher than the absorption of gold compared to the Heap leaching. New technologies are applied in South Africa using ion exchange resins Resin In Pulp (RIP) is expected to lower the operational costs. Preparation of rock (including softening, solution concentration, as well as the type of solution) and the leaching time is different for each rock. Oxide rocks the size of 65 mesh requires a 0.05% NaCN (50% solids) with a leaching time of 4 to 24 hours. Sulfide rocks the size of 325 mesh needs 0.1% NaCN leaching time up to 72 (Weiss 1995)

Top Ad 728x90